oreocook.blogg.se - Fldigi and signalink setup windows 10

Fldigi and signalink setup windows 10 drivers#

your transmit audio level setting, which is automatically adjusted.a Signal to noise value, which is hopefully in the high 20’s or low 30’s ie: “27dB SNR”.Two numbers will be displayed in your SoundCard Window –.At the end of the 11th transmission the gateway node will respond.Your radio should key up and will send 11 transmissions with increasing tone levels.Enter the node callsign in the callsign box (W7ACS-10), then click the electrical plug icon to the right.Click the RED auto-tune button on the right side of the SoundCard window.Click the Tune button to turn off the transmitter.Adjust the transmit pot (R14 or R16 depending on the position of JU3) until the tone, heard in the second radio is just below the level of a normal voice transmission.Tune a second radio to the same frequency to listen to your signal.Choose one of the W7ACS-10 RMS gateway frequencies for example in Channel selector menu forthe Seattle Area.

Tune your radio to the frequency of a node which you expect will have a good RF signal to your location.

In VARA FM click Settings, and the select Sound Card from Menu.

Adjust the RX level pot (R12) so the meter is at 1 o’clock.

The VARA VU meter should read in the green, ideally about 1 o’clock on the dial.

Monitor an clear channel with no activity, no squelce.

Here are images of what my choices appear on my screen Tuning from the Settings/SoundCard menu

You may need to try both -1 and -2 to see which one the DRA is using.

The #’2′ may be different for your install.

The DRA’s sound card can be confirmed by unplugging the DRA, the correct sound-card will disappear from the list.

The DRA will automatically slow down to 1200 to accommodate slow connections. be sure that JU5 is on the “B” side for 9600 baud. a quick guide to installing NTP on Windows XP, Vista, or Windows-7/8/10.

Fldigi and signalink setup windows 10 drivers#

FM System should be WIDE (NARROW here for Signalink type interfaces). FLDIGI and Icom IC-7100 Setup Download USB Drivers The latest drivers can.Go to the open window labeled Vara FM (mine says Vara FM 4.2.2) The session setup is the same as any other sound-card interface.Open Winlink Express then choose VARA FM winlink on the pull down menu (upper right of the winlink menu) and click on Open Session.Plug the DRA module into your radio and into a USB port on your computer.